FLARING FC-500 - Table of Contents; Contents

2
Version
Due to product version upgrades or other reasons, the contents of this document are not regularly updated. Unless
otherwise agreed, this document is intended as a guide only and all statements, information and recommendations in this
document do not constitute any guarantee, expressed or implied.
The pictures in this document are for reference only. If the picture is different from the real one, then use the pictures for
guidance only.
Contents
Contents ....................................................................................................................................................... 2
1 Product brief introduction .......................................................................................................................... 3
1.1 Summarize .......................................................................................................................................3
1.2 Technical parameters .......................................................................................................................3
1.3 Accessories list ................................................................................................................................ 4
2 Installation instruction ................................................................................................................................4
2.1 Installation of Air Regulator ..............................................................................................................4
2.2 Air compressor connect to plasma cutter ........................................................................................5
2.3 Plasma Cutter Torch connect to machine ....................................................................................... 5
2.4 Cutting Torch explosive chart .......................................................................................................... 6
3 Operating instructions ............................................................................................................................... 6
3.1 Operation panel interface ................................................................................................................ 6
3.2 Cutting Operation instruction ...........................................................................................................7
3.3 Start Cutting ..................................................................................................................................... 8
3.4 Hand torch cutting Show ............................................................................................................... 10
4 Trouble shooting and fault finding ........................................................................................................... 11
5 Daily maintenance and checking ............................................................................................................ 12
5.1 Daily maintenance ......................................................................................................................... 12
5.2 Daily checking ................................................................................................................................12
5.3 Cutting problems and resolution ....................................................................................................13
6 Attention ...................................................................................................................................................14
6.1 Cutting environment and safety .....................................................................................................14
6.2 Symbol definition: .......................................................................................................................... 14
7 Service GUARANTEE .............................................................................................................................19