What to do if the FLARING FC-500 Cutter arc is not striking?
If the FLARING Cutter is not striking an arc during operation, first ensure that the input voltage is adequate. Also, verify that the air compressor pressure is within the correct range.
Overview of the cutting machine's core technology and features.
Detailed specifications including power, current, thickness, and dimensions.
Step-by-step guide for installing the air pressure regulator.
Instructions on connecting the air compressor to the plasma cutting machine.
Guide for connecting the plasma torch to the cutting machine.
Diagram illustrating the components of different cutting torches and their wear parts.
Explanation of the controls and indicators on the machine's operation panel.
Detailed steps for performing cutting operations, including preparation and adjustments.
Procedures for initiating cutting, covering edge cutting and piercing.
Factors influencing cutting quality such as amperage, speed, and tip condition.
Visual guide to correct torch height, position, speed, and amperage for cutting.
Routine cleaning and checks to ensure proper machine function and longevity.
Procedures for daily inspection of power supply, cables, and cutting torch components.
Addresses specific issues like arc starting difficulty and unstable current with potential causes.
Guidelines for safe working environments, including temperature, humidity, and ventilation.
Explains safety symbols (DANGER, WARNING, ATTENTION) and their meanings.
Crucial safety advice regarding electric shock, fire hazards, fumes, and equipment handling.
Specific warnings about arc hazards, gas cylinder safety, switch operation, and wire end dangers.
Guidance on managing electromagnetic interference during operation and installation.
To Next Page
General