FLARING FC-500 - Operational Handling Safety

17
The arc, spark, residue and noise are harmful to health, please wear protective appliance.
 Eye protection against arc is recommended when cutting or supervise cutting.
 Please wear preventive spectacles.
 Welder’s gloves, welder’s goggles, long sleeve clothes, leather apron, and other standard protection equipment
must be worn for cutting operation.
 A screen to protect other people against the arc must be set in the cutting place.
Please follow the notes below to avoid gas cylinder toppling over or broken.
 Use the gas cylinder correctly.
 Use the equipped or recommended gaseous regulator.
 Read the manual of gaseous regulator carefully before using it, and pay attention to the safety notes.
 Fix the gas cylinder with appropriative holder and other relative parts.
 Never put the cylinder under high temperature or sunshine environment.
 Keep your face away from the gas cylinder exit when opening it.
 Put on the gas shield when it is not used.
 Never put the torch on the gas cylinder. The electrode can not meet the gas cylinder.
Any touch of the switch part will cause injury, please note the following.
 Never use the machine when the enclosure is off.
 Install, operate, check and maintain the machine by professional person.
 Keep your fingers, hair, clothes etc. away from the switch parts such as the fan.
The wire end may deal damage, please note the following.
 Never look into the electric conduction hole when checking the wire feeding is normal or not, , or the shooting wire
may stab your eyes and face.
 Keep your eyes, face or other naked parts away from the end of torch when feeding the wire manually or pressing
the switch.
For better work efficiency and power source maintenance, please note the following.
 Precautions against toppling over.
 Never use the cutting equipment for pipe thawing.
 Lift the power source from side when use the up-down forklift truck to avoid toppling over.
 When using the crane for lift, tie the rope to the ears with an angle no more than φ15 to the vertical direction.
 When lifting the cutting machine which equipped with gas cylinder and wire feeder, download them from the power
source and ensure the horizontal of the machine. Do fix the gas cylinder with belt or chain when moving it to avoid
body hurt.
 Ensure fastness and insulation when lifting the wire feeder through the swing ring for cutting.