The magnetism created by energizing the cutting machine can have a bad effect to the pacemaker.
Install, operation, check and maintain the equipment by profession personnel.
Understanding the contents of the user manual for safety.
Please follow the rules below to avoid electric shock
。
Keep away from any electric parts.
Earth the machine and workpiece by professional personnel.
Cut off the power before installation or checking, and restart 5 minutes later. The capacitance is chargeable device.
Please ensure it has no voltage before start again even if the power source is cut off.
Do not use wire with inadequate section surface or damage insulation sleeve or even exposed conductor.
Do ensure well isolation of wire connection.
Never use the device when the enclosure is removed.
Never use broken or wet insulation gloves.
Use firenet when work at high position.
Check and maintain regularly, don’t use it until the broken parts are fixed well.
Turn off the power when not in used.
Follow the national or local related standard and regulations when using the AC cutting machine at narrow or high
position.
Please follow the below notes to avoid fire and explode, etc.
No combustible in cutting area.
Keep off combustible when cutting.
Keep hot workpiece after cutting away from flammable gas.
Do move away the combustible around when cut the dooryard, ground and wall,.
The wire connection of base metal should be as close to the cutting place as possible.
Never cut those facilities with gas pipe or airtight slot.
Put fire extinguisher around the cutting area to prevent fire.
The gas and fumes are harmful to health, please wear protective device according to
regulations.
Wear exhaust equipment and breathe preventive facilities to prevent gas poisoning or choke.
Use suggested part exhaust equipment and breathe preventive facilities to prevent hurt or poisoning by gas and
other powder, please.
To prevent oxygen-deficiency, air out the gas-filled room which is full of CO2 and argon on the bottom, When
operating on trunks, boilers, cabins, etc.
Please accept the supervisor’s inspection when operating in narrow space. Air the room and wear breathe
preventive facilities.
Never operate in degrease, washing or spray space.
Using breathe preventive facilities when cut shielded steel for it will cause poisonous dust and gas.
To Next Page
Loading...
