Why is the arc not striking on my FLARING FL-550D Cutter?
If your FLARING Cutter isn't striking an arc during operation, it could be due to a couple of reasons. First, the input voltage might be too low. Second, the air compressor pressure could be either too high or too low.
Details inverter technology, wide voltage, ease of use, and suitability for various materials.
Lists key specifications including input voltage, current, cutting thickness, and dimensions.
Identifies included items like the plasma cutter torch, pilot arc, and ground wire.
Provides step-by-step instructions for installing and adjusting the air pressure regulator.
Explains connecting the air compressor and plasma cutting torch to the machine.
Displays an exploded view of the cutting torch, identifying wear parts.
Describes the function of the current display meter, power light, and protection indicators.
Details input cable connection, air compressor connection, and initial power-on steps.
Covers edge cutting technique, pulling the trigger, and arc initiation.
Discusses amperage, speed, direction, torch height, tip size, and electrode condition for quality cuts.
Illustrates correct torch height, position, speed, and amperage for effective cutting.
Lists common operational faults and their respective resolvable methods.
Procedures for removing dust, checking connections, and preventing moisture.
Details daily checks for power supply, cables, and the cutting torch.
Addresses issues like arc starting difficulty, output current deviation, and unstable operation.
Guidelines on working surroundings, ventilation, overload, and voltage protection.
Explains hazard symbols (Danger, Warning, Attention) and their associated risks.
Advises on potential electromagnetic interference and user responsibilities.
Outlines the warranty period, terms, and conditions for the cutting machine and accessories.
To Next Page
General