FLASHFORGE 3D PRINTER Adventurer 4 - User Manual

快速启动指南
Adventurer 4 / 冒险家4
Quick Start Guide
EN/CN/DE/FR/한-A01
本手册仅适用于闪铸科技 冒险家4 3D打印机
This guide is only applicable to FLASHFORGE Adventurer 4 3D printer
WARNING
注意事项
1. Do not remove the wrapping around the nozzle.
2. Hot! Avoid touching the heating nozzle in operation.
3. Moving parts in printer may cause injury. Do not
wear gloves or other sources of entanglement in
operation.
1. 切勿去除包裹在喷嘴处的耐高温材料。
2. 高温危险！打印机喷嘴在工作时会被加热，操作时请避免
接触!
3. 可动部件可能会造成卷入挤压和切割伤害。操作机器时请
不要配带手套或缠绕物。
EN P01 / CN P06 / DE P11 / FR P16 / 한 P21

Summary

Quick Start Guide

Safety Precautions

Essential safety warnings regarding nozzle temperature, moving parts, and entanglement hazards.

Component Introduction

External Printer Components

Identification of external parts including power, ports, covers, and interface.

Internal and Functional Components

Identification of internal parts like extruder, nozzle, fans, and filters.

Packing Specification

Included Accessories

List of all items included in the printer package, such as cables, tools, and media.

Getting Started

Software Installation

Instructions for installing the necessary software from the USB disk or download center.

Device Preparation

Guidance on initial device setup and calibration after unpacking.

Connecting to Power

Steps to connect the printer to a power source and turn it on.

Loading Filament

Steps to load filament into the printer, including visual cues for success.

Model File Transfer

Methods for transferring model files to the printer, including Wi-Fi and USB.

Model Removal

Procedure for safely removing finished prints from the build plate.

FLASHFORGE 3D PRINTER Adventurer 4 Specifications

General

Brand	FLASHFORGE 3D PRINTER
Model	Adventurer 4
Category	3D Printers
Language	English