Need help?Do you have a question about the FLASHFORGE 3D PRINTER Creator and is the answer not in the manual?
Lists the components included in the Creator 3D printer package.
Detailed steps for loading filament into the extruder, including LCD and control panel methods.
Instructions for feeding material using the printer's LCD screen interface.
Steps for feeding filament using the Replicator G software control panel.
Instructions for removing filament from the extruder, including the LCD and control panel methods.
General| Filament Diameter | 1.75 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, SD Card |
| Display | LCD |
| Print Speed | 100 mm/s |
| Supported Materials | ABS, PLA |
| Power Requirements | 110-220V, 50-60Hz |
| Layer Resolution | 0.1-0.5 mm (100-500 microns) |
| Extruder Quantity | 2 |
| Print Technology | Fused Deposition Modeling (FDM) |
To Next Page
