第 十一 页 共 十一
Software installation
ReplicatorG0040 is the ideal software to drive your dual extruder Creator. It can be
downloaded from our official website:
http://www.sz3dp.com/% E9% A9% B1% E5% 8A% A8% E4% B8% 8B%
E8% BD% BD /
Click Data Download, open creator Series driver, and then you can see the download
link
Download the 3 extracting packages in the red box and decompress them one by one.
Then install the python installation file and python acceleration components. Then
click replicatorg-0040 which is the decompressed file of replicator G.
0040 Flashforge in the red box is the run the motion software, and you will see it by
double-clicking
To Next Page
Loading...
