第 二十七 页 共 二十七
It shows that the heating of the sprinkler and bottom plate is normal.
Feeding and withdrawing filament
Some users report that it’s easy to feed filament, while others report that it’s hard --
what would explain this? Sometimes, if the location is wrong (trying to operate at
different angles), the filament feeding wheel is not secure and the material cannot be
fed. To prevent this, please do the following:
After putting the filament into the feeding hole, do not push it further until the
extruder temperature reaches 200 degrees or more, and not until you can feel that the
filament is being drawn in.
Withdrawing of filament is the same; the material cannot be withdrawn until the
temperature reaches 200 degrees or more. Put your hands on the filament near the
feeding hole and withdraw it only once you feel that the material is being discharged.
To Next Page
Loading...
