第 二十九 页 共 二十九
Feeding the material by LCD option
1. When you start your machine, the display indicates:
Build from SD
Preheat
Utilities
2. Click the button board on the right, and then click the page down key to advance
to the second page. The display indicates:
Preheat
Utilities
Info and Settings
3. Select Utilities; click the M key in the middle of the button board. The display
indicates:
Monitor Mode
Change filament
Level Build Plate
Home Axes
Feed operation with LCD screen
4. Select Change filament. Click the M key in the middle of the button board. The
display indicates:
Load Right
Unload Right
Load Left
Unload Left
5. Select Load right. Click the M key on the button board. The display indicates: I'm
heating up my extruder! At this time, the temperature of the right nozzle is being
heated up. When the temperature reaches 220 degrees, click the M key on the
button board. The nozzle should spit material. If it does not, keep clicking the M
key until it is done.
Feed operation using Replicator G control panel
To Next Page
Loading...
