第 三十一 页 共 三十一
How to withdraw the filament
1. When you start your machine, the display indicates:
Build from SD
Preheat
Utilities
2. Click the button board on the right, and click the page down key to advance to the
second page. The display indicates: Preheat
Utilities
Info and Settings
3. Select Utilities. Click the M key in the middle of the button board. The display
indicates: Monitor Mode
Change filament
Level Build Plate
Home Axes
4. Select Change filament. Click the M key in the middle of the button board. The
display indicates:
Load Right
Unload Right
Load Left
Unload Left
5. Select Unload right. Click the M key on the button board. The display indicates:
I'm heating up, my extruder! At this time, the temperature of the right nozzle is
being heated. When the temperature reaches 220 degrees, click the M key on the
button board. The nozzle will discharge material. If it does not discharge, continue
to click the M key until it is done.
To Next Page
Loading...
