Flashforge Adventurer 5M - 1. Equipment Introduction

01 02
03
04
05 06
07 08 09 10
11 12 13
14
15 16 17
18
19
20
21
22
23
24
25 26
27
28
29
Step 2
Guard Plate B1
Screw M3*8
Nut M3
Guard Plate B2
Remove the top two M4*6 screws from the machine, then install the guard plates B1
and B2 with hinges installed and lock them, and secure them with six M4*6 screws.
Re-install the two M4*6 screws.
Step 3
Install Guard Plates B1 and B2
1. Assemble the guard plates B1 and B2.
2. Insert four M3 nuts into the slots of the guard plates, and then fix the upper and lower
hinges onto the guard plates with four M3*8 screws.
Install Hinges
Guard Plate B1
Screw M4*6 ×6
Guard Plate B2
30
31
32