Flashforge Adventurer3 - Change Filament; Initiating Filament Replacement; Unloading and Loading Filament

Heating extruder...
1. Tap [Filament]--Tap [Change], extruder will start preheating.
2
. Pull out the filament as the picture
showed above.
4
. When new filament come out of extruder steadily, replace is completed, Tap [OK].
3. Insert new filament into the filament intake
and push the filament into the feeding wheel
until resistance is sensed.
Load
Change
200
/235℃
Cancel
220
/235℃
235
/235℃
OK
235
/235℃
OK
Unloading the filament,
please wait...
Pull out filament,
feed new filament, press [OK]
Press ok when new color appears
Change Filament
09