Loading Filament
1. Tap [Tools]. 2. Tap [Filament].
3. Tap [Load], extruder starts to heat.
4. Once heated, filament will be drawn through the extruder. Continue extruding until the extruder
provides a steady flow of filament. Tap touch screen button, go back to home screen.
Done
Loading started, push filament vertically
into extruder and press [Done] when you see
filament come out of the extruder
10
Attetion: If extruder can not unload in a long time, please check if you have inserted filament
into the bottom of extruder.
To Next Page
Loading...
