1. Please insert the USB stick into USB stick
input on the right side of the printer. Tap [Build].
2. Tap [USB Stick].
3. Tap [Test Files].
5. Tap [Build].
6. The printer starts to heat and it prints
automatically after heating completed.
4. Tap [40mm_Box-PLA.gx].
Quick Start Guide 快启
Test Files 测试文件
User Guide 说明书
Flashprint切片软件
PLA
PLA
11
1. Ensure that the build plate has been leveled before
printing.
2. Ensure that the filament has been loaded in an
appropriate approach.
3. Load the filament for a while to extrude all the
melted filament you printed last time out of the
extruder.
4. Please clean extruder before printing.
5. Do not leave the printer unattended during
operation.
To Next Page
Loading...
