2.3.7 Remove the 6 off screws to remove the burner gauze, then 4 off screws
to remove the ceramic support and finally 4 off burner mounting screws
as shown below in figure 8, then lift the burner unit clear of the firebox.
Fig. 8
2.3.8 With the burner removed from the firebox, plan the routing of the gas
supply pipe into the firebox. See overpage, section 2.3.9 for suggested
pipework routing.
15
Burner unit -
held in position
by 4 off securing
screws
Burner gauze -
held in position by
6 off screws
Creramic support -
held in position by
4 off securing
screws
To Next Page