Fleck 9000 - Job Specification Sheet; Control Valve Specifications

MODEL 9000 ECONOMINDER

Job Specification Sheet
Printed in U.S.A.
* JOB NO. __________________________________________________________
* MODEL NO. _______________________________________________________
* WATER TEST______________________________________________________
* CAPACITY PER UNIT ____________MAX. ___________PER REGENERATION
* MINERAL TANK SIZE DIA.________HEIGHT_________
* BRINE TANK SIZE &
SALT SETTING PER REGENERATION _________________________________
Page 2
* 9000 CONTROL VALVE SPECIFICATIONS
1. Type of Timer
A) 82 minute available regeneration time, 1/15 RPM
B) 164 minute available regeneration time, 1/30 RPM
2. Type of Meter (see page 23)
A) 3/4″ meter *Std. range 125 to 2,100 gal. setting
*Ext. range 625 to 10,625 gal. setting
B) 1″ meter *Std. range 310 to 5,270 gal. setting
*Ext. range 1,550 to 26,350 gal. setting
3. Meter Gallon Setting ____________________________gal. (see pages 6 & 7)
4. Regeneration Program Settings (see page 5)
A) Backwash _________________________________min.
B) Brine & Slow Rinse _________________________min.
C) Rapid Rinse _______________________________min.
D) Brine Tank Refill ____________________________min.
5. Drain Line Flow Control__________________________gpm
6. Brine Refill Rate________________________________gpm
7. Injector Size __________________________________