MODEL INFORMATION
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. They are
located differently for each model. Areas such
as the hall walkway, under the bed, below the
refer or in outside storage compartments are
typical locations.
04-1
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specied on the
device or label. Doing so constitutes a re hazard.
!
CAUTION
Before re-lamping, disconnect power source by remov-
ing fuse or placing circuit breaker and control switch in
OFF position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not handled correctly.
Always use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near ammable or combustible materials
and/or objects which may be sensitive to fading or dry-
ing.
Use bulbs designed or specic by manufacturer as to
style, wattage and voltage.
To Next Page
Loading...
