LiviNq
WiTh
YOUR
MOTOR
HOME
To convert a sofallounge into a bed:
1.
Remove sofa bolsters.
2.
Lift front of sofa frame up and out.
3. Push the back of the lounge back and down.
4.
Push the seat belts through the space between the lounge
back and seat.
To
restore the sofallounge:
1.
Pull the seat belts back up through the space.
2.
Lift the front edge of the sofa frame
up,
and push it back.
The sofa back
will come
up.
3.
Push the sofa into position.
Both decorative and "utility" style 12-volt lighting fixtures
may be used in your motor home.
Utility style fixtures may be either single or dual. A slide
switch selects either single or dual brightness. For your con-
venience, some lights are operated from wall switches. Clean
the lenses with soapy water.
Overhead vents are located in the galley and bathroom areas
for fresh air circulation and exhausting heat, odors and water
vapor.
Thrn the crank in the center
of
the vent to open and adjust.
Some vents may also be equipped with a 12-volt fan. A
switch controls fan operation. Be sure to turn the fan
OFF
before closing the vent.
Close the vents or lower them before traveling
to
avoid dam-
age from wind and low overhead clearances.
SOFA/LoUNGE
CONVERSION
INTERIOR LIGHTING
OVERHEAD
VENTS
To Next Page
Loading...
