EasyManua.ls Logo

Fleetwood Bounder - Filling the Water Tank

Fleetwood Bounder
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PlIJMbiNq
SYSTEMS
On some models, you can fill the fresh water tank from the
city water connection.
Open the tank fill valve and remove
the fresh water tank fill cap and vent plug. Monitor the fill-
ing
of
the tank continually. The flow and pressure at some
park and city water supplies could damage the tank
if
left
unattended. After filling the tank, close the valve, replace
tank fill cap and vent plug.
o
Filling the Water Tank
The on-board water storage tank may also be filled through a
special filler cap outside the motor home.
To
fill the fresh
water tank, open the spout, remove vent plug, and fill the
tank using a potable water hose. Check the monitor panel
often to determine when the tank is full.
If
water is flowing
from the top vent, your tank is overfilled. Stop filling. After
filling the tank, replace vent plug and filler cap.
Avoid leaving water in the tank when the motor home is not
in use. Turn the water pump
OFF before draining the water
tank. Whenever possible, drain the fresh water tank before
traveling. Water in the tank will reduce the carrying capacity
of
the motor home. See Motor Home Loading section
of
the
On The Road chapter.
FILLING
THE
WATER
TANK
CAUTION
Overfilling the fresh water
tank from a pressurized
source will cause serious
damage to the water tank
or
structural components .
Monitor water tank
filling
continually.
BOUNdEII

Table of Contents

Other manuals for Fleetwood Bounder

Related product manuals