LiviNlj
Wirh YOUR MOTOR HOME
The vent may be cleaned from the top
of
the motor home.
Use soapy water on the vent cover. The screens may be vacu-
umed or lightly brushed to remove accumulation
of
leaves or
other debris.
Lubricate the gears and mechanism yearly with a light, water
resistant grease.
The monitor panel allows you to conveniently check the
approximate levels in tanks and to check battery condition(s).
Electrical probes installed in the tanks measure the levels at
various points in the tanks.
To
check
tank
levels:
Press LP GAS, WATER or HOLDING TANK 1 or 2 rocker
switches.
HOLDING TANK 1 is the black water (toilet waste)
tank, and
HOLDING TANK 2 is gray water (sink and shower
wastes).
The
"E" or empty indicator light will always be lit when the
rocker switches are depressed. If the tank is full, all lights
will
be on. Lights are sequential, and indicate the level in
approximately
Y4
tank increments. If the tank selected is
approximately
Y2
full, for example, lights
E,
'!. and
Y2
will be on.
Erroneons
tank
level indications
can
be caused by:
a.
Water with low mineral content. The level is measured by a
very low level electrical signal traveling through the liquid.
Some
water may not conduct the signal properly. This con-
dition may be infrequent, but can exist. Check the panel
reading when the fresh water tank is filled.
b.
Material trapped on the sides of the holding tanks may
give
a full reading when the tank
is
actually empty.
BOUNdm
MONITOR
PANEL
v'1
NOTE
If
the sensor probes
mounted
in
the
tanks get
coated with grease,
the
monitor panel may indi"
cate falsely or not
at
al/.
Avoid pouring grease,
oils
or
similar substances
down drains or
the
toilet.
If
this is unavoidable,
the
holding tank(s) should
be
washed out with a soapy
water solution.
See
your
dealer for additional
information.
To Next Page
Loading...
