PLUMBING
SYSTEMS
The
plumbing systems in your motor home are constructed
of
thermoplastic materials. Holding tanks and piping compo-
nents are strong, lightweight, and corrosion resistant.
Fresh water is available from either an external
"city water"
hookup or on-board storage.
The
external system is pressurized by the water system at an
RV park or city water supply.
On
some models, a manual valve also isolates the on-board
fresh water storage tank. This valve can be used to fill the
tank from the city water supply.
Connect
the
city
water
system
as
follows:
1.
Open the protective door over the city water inlet (on some
models only).
2. Connect one end of a potable water hose to park or city
water
supply. This will usually be a faucet or valve similar to
your garden hose
valve at home. "Potable water" hoses are
available at
RV
supply stores.
3.
Run the city water supply for a few seconds to clear the
line.
4.
Turn OFF the supply.
5.
Connect the hose to the inlet fitting.
6.
Turn ON the supply. Open all faucets and clear the lines.
Close
faucets.
Disconnect
the
city
water
as
follows:
1.
Close the park or city water supply valve.
2.
Remove the hose from the city water supply valve.
3.
Disconnect the hose from the inlet, coil and store
it.
BOUNdER
:
FRESH WATER
SYSTEM
CITY
WATER
CONNECTION
""
""
City Water Connection
To Next Page
Loading...
