PlUMbiNq
SYSTEMS
To
drain the holl;ling tanks:
1.
Attach the sewer hose to the holding tank outlet. Insert the
end of the hose into the sewer or dump station inlet, push-
ing it firmly far enough into the opening to be secure.
In
some cases, adapters may be necessary between the line
and the inlet. Arrange the sewer hose so it slopes evenly.
2. Drain the black water holding tank first. Grasp the handle of
the
black water knife valve (the large one) firmly and slide
the valve open with a quick, steady pull.
3.
Allow enough time for the tank to drain completely. Rinse
and
flush the tank through the toilet. When the tank is
empty, push the handle
in
to close the valve. Run enough
water into the tank to cover the bottom. This
will aid the
break up of
solid wastes.
4.
To
drain the grey water tank, repeat the steps above using
the small knife valve. This tank is drained last to aid
in
flushing the outlets and hose. The grey water knife valve
may be left open in a semi-permanent hookup.
5.
Remove the sewer hose and cap the outlet.
6. Rinse out the sewer hose with fresh water and remove the
sewer hose from the dump station.
7.
Replace sewer or dump station covers.
Grey Holding Tank Dumping
Black Water Tank Dumping
Please
...
Practice good house-
keeping when draining wastes
at a campsite or disposal sta-
tion. Leave the site in good
order. Above all,
do
not
pollute.
BOUNdER
To Next Page
Loading...
