o
If
your refrigerator is equipped with an ice maker, win-
.
terize it as follows:
1.
Shut off the water supply valve to the ice maker.
2.
Place a shallow pan under the water solenoid valve.
3.
Remove the inlet fitting to the ice maker water solenoid
valve.
Drain the water from the supply line.
4.
Remove the plastic nut and water line from the outlet side
of the water
solenoid valve. Drain water from the line.
5.
Cycle the ice maker several times while blowing com-
pressed air through the water solenoid valve.
Be
sure all
water
is
out of the solenoid. NOTE: Your motor home
dealer can do this for you.
6.
Reconnect and tighten the lines on the solenoid valve.
Leave the water supply turned off until temperatures are
above 32 degrees
F.lO
degrees
C.
7.
Dry out the ice maker mold assembly with a soft cloth.
Place the bail arm to the UP/OFF position.
PACE
ARRow
To Next Page
Loading...
Need help?
General
