o
o
o
o
o
o
o
01
o
o
Be sure engine instruments indicate proper readings ..
Run engine up to operating temperature. Shut engine
down. Check all fluids. Top off
if
necessary.
During engine run, check the operation
of
headlights,
tail-lights, turn signals, backup lights, clearance lights,
license plate light, emergency flashers. Check the
exhaust system for leaks or deterioration. Operate the
vehicle air conditioner.
If
air conditioner does not
work, or unusual sounds occur, have the system
checked by a qualified air conditioner technician.
Drain, flush, and sanitize the fresh water system as out-
lined in the
Plumbing chapter. Inspect the drain hose
for leaks. Replace
if
necessary - repairs are usually
not effective.
Install a new water filter cartridge (if equipped).
Operate all faucets and fixtures in the fresh water sys-
tem. Check for leaks at all joints and fittings. Repair
if
necessary.
Check 12-volt circuit breakers and inspect fuses.
Operate all 12-volt lights and accessories.
Install new batteries in battery-operated devices. Check
operator's manual for each device for additional
requirements.
Test carbon monoxide, LP gas and smoke
detectors/alarm.
Check monitor panel operation.
1-
I
--
PACE
Annow
To Next Page
Loading...
Need help?
General
