Page 13 of 18
Air Connection:
This connection is on the right back side of the machine looking from the control side
and near the chip conveyor exit. There is a filter with a filtering capacity of 5 seconds
with automatic purge. Provide enough flow of dry and clean air to the machine with a
pressure between 90 and 101 psi of dry and clean air.
The air connection needs to comply with ISO 8573-1 to optimize the operation of the
machine. This norm establishes the following characteristics for the air:
• SOLIDS:
➢ Category 3: 5m
• POINT OF WATER CONDENSATION:
➢ Category 4: +37.4 ºF
• MAXIMUM OIL CONTENT:
➢ Category 3: 1 mg/m³
• AIR CONSUMPTION
➢ 87 psi – 101 psi
• CYCLE OF TOOL LOAD:
➢ Tool cleaning .456 ft3
➢ Tool clamping .106 ft3
➢ Base doors and base elevation .167 ft3
➢ TOTAL CONSUMPTION .728 ft3
• CYLINDER BRAKE MOVEMENT
➢ X/Y/Z 1.37 ft3/min.
To Next Page
Loading...