Page 5 of 18
Technical Data:
Construction:
Welded frame made with structural tubes allow for greater absorption of vibrations and
are more rigid and stable. Gantry is made from welded steel plate with reinforcing ribs
to increase rigidity.
Linear guides:
The linear are made from tempered steel, polished and ground to allow for a low
friction coefficient. This allows for 1200 in/min in the X-axis, 1000 in/min in the Y-axis
and 350 in/min in the Z-axis.
Automatic Tool Changer:
The tool changer can accommodate up to 14 CAT40 tools (10 CAT50) and the positioning
is controlled by a rotary motion servomotor. The tools are inserted directly in the axis
without the use of an intermediate handling devise. During each tool change an air blast
is initiated to clear the spindle of coolant and debris.
Lubrication System:
Machine bearing mounts, ball screws, etc. are all self-lubricating.
To Next Page
Loading...
Need help?
General