03 04
Attach the crossbeam (7) to the lifting columns (3 & 4) with the M8 bolts (C) and tighten them down
with the 5x5 hex key (F).
Step 3:Install crossbeam
Step 2:Install transmission rod
To install the transmission rod, first slot it into lifting column (3) and loosen the hex bolt (Figure. 1).
Extend the transmission rod and slot it into the motor on lifting column (4), then tighten it down with
the included 2.5x2.5 hex key (F) (Figure. 2).
R
o
t
a
ry i
n
s
e
r
t
Note: Please insert the
transmission rod until shaft
stopper touches the column
(Figure.1).
Warning: To ensure both lifting
columns move evenly, do not
rotate the transmission rod more
than 1/3 turn when inserting it into
the motor (Figure. 2).
F
2.5 5x2.
3
4
8
1
2
C
X4
F
5 5x
7
F
C
3
4
To Next Page
Loading...
