System dismantling and disposal
Created by EBCCW 00:06
29
5814EN-3
5.2 Dismantling end drive units with suspended
motor
The locking effect of the slip clutch can be removed by removing the trans-
mission chain or by releasing the slip clutch (section in maintenance and
service refers to slip clutch adjustment).
Remove the motor gear unit from the conveyor drive assembly. The motor
gear unit may be fitted with an oil breather. Ensure that the oil from the
gearbox cannot leak into the surrounding area when decommissioned. Oil
should be drained from the gearbox and disposed of in accordance with lo-
cal environmental regulations.
1 4
2 5
3 6
To Next Page
Loading...