3 Introduction
Thank you for choosing a FLIR CM83 clamp meter.
This device is shipped fully tested and calibrated and, with proper use, will pro-
vide years of reliable service.
3.1 Key features
• 10 000-count digital display.
• Large-scale display.
• Analog bar graph.
• True RMS reading in AC and AC+DC mode.
• Work light.
• Auto AC/DC 600 A capability and selection.
• Auto AC/DC 1000 V capability and selection.
• Auto resistance/continuity/diode selection.
• Power and power factor measurement.
• Total harmonic distortion and 1 to 25 harmonics.
• Phase rotation Indication.
• 100 kΩ resistance capability.
• Non-contact voltage detector.
• Frequency measurement.
• Capacitance capability.
• Smart data hold.
• Peak hold.
• In-rush current.
• DCA zero key.
• Minimum/maximum and average hold.
• VFD mode – Low-pass filter.
• Auto power off.
• Jaw opening 37 mm (1.45") for conductors up to 1500 MCM.
• 1.2 m (4′) drop-proof.
• Convenient battery cover.
• Safety Category Rating: CAT IV-600V, CAT III-1000V.
#T559825; r. AI/33557/33557; en-US 7
To Next Page
Loading...
Need help?
General
