910-0001-00-INS -R02 Page 38 of 53
Information contained in this document pertains to a Canadian origin product that is controlled as "dual use" by the Canadian
government. However, when in the United States or possessed by a US person, it may be considered a defense article from the US Government's
perspective. US government authorization may be required for re-transfer to a foreign person. If you have any questions, please contact FLIR's
Global Trade Compliance group at exportquestions@flir.com .
Step 1 In Radar Console application, program the RD_target_up_az parameter with the value
established, as shown in Figure 66
Step 2 Press the
button
Figure 24 – Configuring the Target Azimuth Update
5.2 CONFIGURING THE CHIRP SLOTS
When two or more R1, R2, R3, R3D, R5 and R5D Radar Assemblies are used at the same site, each unit
must be given a different frequency slot or a different time slot (or chirp slot) if they use the same
frequency slot. This prevents the units from interfering with one another. If only a single unit is involved,
any frequency or chirp slot can be used. It is recommended to always use synchronization method 2
unless the GPS reception is obstructed.
To Next Page
Loading...
Need help?
General
