Camera parts
10
Note
• The symbol
is displayed on the screen when the laser pointer is on.
• The laser pointer is enabled by a setting. Select
(Settings) > Device settings >
Set up camera > Lamp & laser > Enable lamp & laser.
Note The laser pointer may not be enabled in all markets.
10.8.2 Laser warning label
A laser warning label with the following information is attached to the camera:
10.8.3 Laser rules and regulations
Wavelength: 635 nm. Maximum output power: 1 mW.
This product complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant
to Laser Notice No. 50, dated June 24, 2007.
#T559954; r. AP/42311/42335; en-US
24
To Next Page
Loading...
