Handling the camera13
13.1.4 Using the stand-alone battery charger to charge the battery
13.1.4.1 Procedure
Follow this procedure:
1. Put the battery in the stand-alone battery charger.
2. Connect the power supply cable plug to the connector on the stand-alone battery
charger.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the green light of the battery condition
indicator is continuous.
See also:
For information about the battery condition indicator, see 8.4 Battery condition indicator,
page 15.
13.2 Inserting the battery
Note
Use a clean, dry cloth to remove any water or moisture on the battery before you insert it.
13.2.1 Procedure
Follow this procedure:
1. Push the release button on the battery compartment cover to unlock it.
2. Open the cover to the battery compartment.
3. Push the battery into the battery compartment until the battery-locking mechanism
engages.
#T559879; r. AG/12171/13006; en-US
22
To Next Page
Loading...
Need help?
General
