Why does my Flotec FP0S1800LTS start and stop frequently?
If your Flotec Water Pump starts and stops too often, it might be due to backflow of water from the piping. To resolve this, install or replace the check-valve. Another possible cause is a faulty float switch, which would need to be replaced.
How to troubleshoot a Flotec Water Pump that won't start?
If your Flotec Water Pump won't start or run, first ensure it's properly plugged into an outlet. If it is plugged in, check the fuse and replace it with a proper size fuse if it's blown. Also, low line voltage can be a factor; check the wiring size from the main switch. If the wiring is OK, contact your power company or hydro authority. If these steps don't resolve the issue, the motor or float switch might be defective and need replacement. Finally, check the impeller for any obstructions that may be preventing it from turning; remove the lower pump body to locate and clear any blockages.
What to do if my Flotec Water Pump delivers little or no water?
If your Flotec Water Pump operates but delivers little or no water, the issue could stem from several causes. Start by checking for low line voltage and inspect the wiring from the main switch; if it's adequate, contact your power company. Inspect the impeller and intake screen for obstructions, and clean them if necessary. If the impeller is worn, defective, or plugged, clean it or replace the pump. If you have a check valve installed, ensure it has a vent hole with a diameter of 1/16" - 1/8" (1.6mm - 3.2mm) drilled between the pump discharge and the check valve, 1-2” above where the discharge pipe screws into the pump discharge and below the waterline. Finally, verify that the check valve is installed correctly.
What to do if my Flotec Water Pump won't shut off?
If your Flotec Water Pump won’t shut off, a defective float switch is a possible cause and should be replaced. Another cause may be a restricted discharge due to an obstacle or ice in the piping, so you should remove the pump and clean both the pump and piping. Also, check if the float is obstructed and remove any obstructions. Finally, a restricted intake screen can also cause this issue; remove the pump and clean the intake screen and the impeller.
Details the basic design and intended use of the submersible sump pump.
Lists technical details such as power, liquid temperature, and discharge sizes.
Presents flow rate data (GPH/LPH) at various lift heights for different models.
Provides electrical requirements and switch settings for each pump model.
Crucial safety guidelines and warnings for proper pump installation and use.
Guidance on assembling and installing the float switch mechanism for pump control.
Step-by-step instructions for physically installing the pump in the sump pit.
Detailed steps for correctly assembling the vertical float switch.
Information on the tethered float switch, emphasizing not altering its preset length.
List of replacement parts specifically for the plastic series of submersible sump pumps.
List of replacement parts for the cast iron series of submersible sump pumps.
Identifies common pump problems, their causes, and recommended solutions.
Terms and conditions of the manufacturer's warranty for the product.
Details products with different warranty periods than the standard twelve months.
Covers general warranty exclusions, limitations, and legal disclaimers.
General| Model | FP0S1800LTS |
|---|---|
| Category | Water Pump |
| Voltage | 115V |
| Phase | 1 |
| Max Flow Rate | 1800 GPH |
| Max Head | 25 ft |
| Discharge Size | 1-1/4 in |
| Material | Thermoplastic |
| Power Cord Length | 10 ft |
| Type | Submersible |
| Switch Type | Float Switch |
To Next Page
