Why does my Flotec FP0S2400A start and stop frequently?
If your Flotec Water Pump starts and stops too often, it might be due to backflow of water from the piping. To resolve this, install or replace the check-valve. Another possible cause is a faulty float switch, which would need to be replaced.
How to troubleshoot a Flotec Water Pump that won't start?
If your Flotec Water Pump won't start or run, first ensure it's properly plugged into an outlet. If it is plugged in, check the fuse and replace it with a proper size fuse if it's blown. Also, low line voltage can be a factor; check the wiring size from the main switch. If the wiring is OK, contact your power company or hydro authority. If these steps don't resolve the issue, the motor or float switch might be defective and need replacement. Finally, check the impeller for any obstructions that may be preventing it from turning; remove the lower pump body to locate and clear any blockages.
What to do if my Flotec FP0S2400A delivers little or no water?
If your Flotec Water Pump operates but delivers little or no water, the issue could stem from several causes. Start by checking for low line voltage and inspect the wiring from the main switch; if it's adequate, contact your power company. Inspect the impeller and intake screen for obstructions, and clean them if necessary. If the impeller is worn, defective, or plugged, clean it or replace the pump. If you have a check valve installed, ensure it has a vent hole with a diameter of 1/16" - 1/8" (1.6mm - 3.2mm) drilled between the pump discharge and the check valve, 1-2” above where the discharge pipe screws into the pump discharge and below the waterline. Finally, verify that the check valve is installed correctly.
What to do if my Flotec FP0S2400A Water Pump won't shut off?
If your Flotec Water Pump won’t shut off, a defective float switch is a possible cause and should be replaced. Another cause may be a restricted discharge due to an obstacle or ice in the piping, so you should remove the pump and clean both the pump and piping. Also, check if the float is obstructed and remove any obstructions. Finally, a restricted intake screen can also cause this issue; remove the pump and clean the intake screen and the impeller.
Describes the submersible sump pump's design, features, and intended use.
Lists technical details including power requirements, liquid temperature range, and discharge sizes.
Details pump performance (GPH/LPH) at various lift heights and conditions.
Provides electrical and switch specifications for different pump models.
Covers essential safety guidelines including power, water use, servicing, and personal protection.
Covers crucial warnings and notices regarding electrical safety, proper installation, and component handling.
Explains assembly for vertical float switches and notes tethered switches are ready for use.
Details sump pit requirements, pump placement, and discharge plumbing installation steps.
Provides crucial advice on operating the pump, including submersion, thermal protection, and manual operation.
Step-by-step instructions for assembling the vertical float switch mechanism.
Notes regarding the tethered float switch, advising not to change the preset tether length.
Lists and diagrams repair parts for plastic series sump pumps (FP0S models).
Lists and diagrams repair parts for cast iron series sump pumps (FPSC models).
Provides common symptoms, probable causes, and corrective actions for pump issues.
Outlines the 12-month limited warranty, exclusions, and claim procedures for Flotec products.
Lists specific product categories and their differing warranty periods.
Details general conditions, limitations, and legal disclaimers for the warranty.
General| Model | FP0S2400A |
|---|---|
| Category | Water Pump |
| Type | Submersible |
| Horsepower | 1/4 HP |
| Max Flow Rate | 2400 GPH |
| Max Head | 25 ft |
| Power Source | Electric |
| Voltage | 115 V |
| Housing Material | Thermoplastic |
| Impeller Material | Thermoplastic |
| Shaft Seal | Mechanical |
| Thermal Protection | Yes |
| Float Switch Included | Yes |
| Discharge Size | 1.25 in |
To Next Page
