3 / 121
Assembly video
1-assemble the hot end and pulley
https://www.youtube.com/watch?v=SXd-tmuTVBM
2-assemble the arm rods
https://www.youtube.com/watch?v=D-iHPY9CRdE
3-assemble the bottom and top base
https://www.youtube.com/watch?v=5EvvP-KoBrA
4-assemble the extruder motor
https://www.youtube.com/watch?v=98RVjEdU3F0
5-assemble X Y and Z axis
https://www.youtube.com/watch?v=nmAOFZcZv5M
6-assemble belt and the nozzle
https://www.youtube.com/watch?v=6GR2SCDUsYs
7-connect the wire
https://www.youtube.com/watch?v=-SipWMv61lQ
Calibration and use video
1.Instructions for use-upload the marlin
https://www.youtube.com/watch?v=BbS3nbppZX0
2.instruction of use-calibrate the right height in marlin
https://www.youtube.com/watch?v=dwIpTNQpI2U
3.instructions of use-start print
https://www.youtube.com/watch?v=qYYwba1IWjc
To Next Page
Loading...
