Need help?Do you have a question about the flsun SuperRacer and is the answer not in the manual?
General| Layer Height/Resolution | 0.05-0.3mm |
|---|---|
| Nozzle Diameter | 0.4mm (default) |
| Filament Compatibility | PLA, ABS, PETG, TPU |
| Connectivity | USB, SD Card |
| Display | Touchscreen |
| Frame | Aluminum |
| Nozzle Temperature | up to 260°C |
| Feeder System | Direct Drive |
| Extruder Type | Single Extruder |
| Filament Diameter | 1.75 mm |
| Printing Speed | 300 mm/s |
| Power Supply | 24V |
Detailed steps for performing the auto-levelling calibration process.
Step-by-step guide for inserting filament into the printer.
Verify and adjust the first layer for optimal print adhesion and quality.
Instructions for installing the recommended slicing software.
Guide to inserting SD card and starting a print job using the software.
Configure printing temperatures, filament operations, and language.
Adjust print speed, fan, and Z-axis height during operation.
Steps to format SD card and upload new firmware to the printer.
Troubleshoot common problems like model adhesion, filament feeding, and nozzle clogging.
Address display errors and issues with the printer's levelling system.
Scheduled maintenance for optimal printer performance and longevity.
To Next Page
