flsun SuperRacer - Install Slicing Software; Slicing Software Installation Guide

6. Click “Adjust Z”
7. Click “Z-0.05”
or “Z+0.05” to
adjust the
height of the Z
8. Adjust the
distance between
the nozzle and
the hot bed to a
proper distance
then click “Cancel”
9. Clean the hot bed
Install Slicing Software
1. Copy the CURA
slicing software
from the SD card
your computer
then double-click
to install
2. Select an installation
location and click “Release”
3. Wait for the
installation to complete
Auto-Levelling
done !