flsun C-PLUS - User Manual

To Next Page

Debug and Print

catalogue

Debug and Print............................................................................................................................................. - 1 -

catalogue...................................................................................................................................................... - 1 -

1 Connect and Software............................................................................................................................ - 4 -

1 Software Introduction.......................................................................................................................... - 4 -

2 Connect printer to PC.......................................................................................................................... - 4 -

3 Repetier and control printer................................................................................................................. - 5 -

1 Software Installation.................................................................................................................. - 5 -

2 Language Settings.....................................................................................................................- 6 -

3 Printer settings.............................................................................................................................. - 7 -

4 Connect the printer....................................................................................................................... - 8 -

5 Panel Introduction.........................................................................................................................- 8 -

6 some important command......................................................................................................- 12 -

2 Leveling and printing............................................................................................................................. - 19 -

1,Calibration......................................................................................................................................... - 19 -

2,Start printing...................................................................................................................................... - 31 -

1 Feeder filament........................................................................................................................... - 31 -

2 Slice............................................................................................................................................ - 37 -

3 slice setting................................................................................................................................. - 39 -

4 printing........................................................................................................................................- 43 -

3 Marlin....................................................................................................................................................... - 45 -

1 Arduino.............................................................................................................................................. - 45 -

2 Marlin................................................................................................................................................ - 45 -

1 Open marlin.............................................................................................................................. - 45 -

2 settings........................................................................................................................................ - 46 -

3 Upload Firmware..................................................................................................................... - 47 -

4 Offline printing........................................................................................................................................ - 49 -

1 load the model....................................................................................................................................- 49 -

2 slice.................................................................................................................................................... - 50 -

3 Export Gcode file...............................................................................................................................- 51 -

4 Copy...................................................................................................................................................- 52 -

5 Printing.............................................................................................................................................. - 52 -

5 Heated bed............................................................................................................................................. - 53 -

6 Problem and advice...............................................................................................................................- 55 -