Need help?Do you have a question about the flsun QQ-S and is the answer not in the manual?
General| Print Technology | FDM (Fused Deposition Modeling) |
|---|---|
| Layer Resolution | 0.05-0.4 mm |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | SD Card, USB |
| Bed Temperature | Max 100°C |
| Operating Voltage | 110V/220V |
| Supported Materials | PLA, ABS, TPU, Wood |
| Display | Touch Screen |
| Frame Material | Aluminum |
| Nozzle Temperature | Max 260°C |
Ensure correct voltage (110V/220V) is selected before operating the printer.
Avoid touching the nozzle and heated bed during operation due to high temperatures.
In case of emergency, immediately turn off the power and contact technical support.
Navigate through the menu to initiate auto leveling and remove the sensor afterward.
Use an A4 paper to test nozzle distance and adjust Z0 via 'Move Z0' and 'Adjust Z' options.
Save the calibrated Z-offset to ensure correct nozzle-to-platform distance for printing.
Fine-tune the nozzle height during an active print using Z+0.1 or Z-0.1 controls.
Address problems with the heated bed or nozzle not reaching the set temperature.
Troubleshoot common issues like motor connection, limit switches, and extruder functionality.
To Next Page
