flsun QQ-S - Safety Precautions; Voltage Setting; Hot Component Warning; Emergency Procedures

Cautions
A
Basic Part
A-3
Packing List
A
Basic Part
A-4
1. The printer default selection voltage is 220V,if you need to use 110V,please change
it before using.
2. The assemble and user manual,software and other files are in the
SD card with printer.
3. The nozzle part and heated bed can produce high temperature when the printer is
working ,so
do not touch them by hand to avoid being scalded.
4. Before the automatic leveling, prepare the leveling sensor and an A4 paper and clean
the nozzle, insert the leveling line;
After the Autoleveling , remove the
leveling sensor, then adjust Z0.
5. In the event of an emergency, please turn off the power immediately and contact our
technical support.
Bottom shell Upper shell Side shell
Optical axis
N0.
Wrench
Screwdriver
Limit switch
Scissors
Shovel
Nozzle wrench
Photo Name
Qty
1 1
1
1
1
1
1
1
1
2
1
1
1
1
1
1
1
1
1
2
3
4
5
6
N0.
SD card
Temp Sensor
Nozzle
Clean Needle
Level sensor
Conductive cloth
Photo Name
Qty
7
8
9
10
11
12
N0.
Spare Screws
Assemble Screws
Power cable
USB wire
Filament
Gloves
Photo Name
Qty
13
14
15
16
17
18
3
4