flsun QQ-S - Precise Bed Leveling; Diagnosing Nozzle Distance; Adjusting Z-Offset During Printing

Precise Leveling
B
Use Part
B-3
1.After automatic leveling, maybe the nozzle is too close or too far from the platform.
2.You can adjust the Z-offset while printing .The value can save
Automatically, There is no need to repeat the operation.
17
18
Nozzle
Nozzle Nozzle
filament
filament
filament
①The nozzle is too
low from the platform
③The nozzle is too
far from the platform
③The nozzle is middle
from the platform
Click Z+0.1
nozzle moves up 0.1
Click Z-0.1
nozzle moves down 0.1
Click Option Click More Z+0 .1 nozzle moves up 0.1
Z-0.1 moves down 0.1