Adjust Z0 before printing
After auto leveling, put
an A4 paper and adjust
the position of Z0
Click ‘Move Z0’
Click ‘Save’
Click ‘Adjust Z’
(The distance between the
nozzle and the platform is
an A4 paper.)
‘+’ nozzle move up
‘-’ nozzle move down
‘0.01mm’ adjust move range
Make sure the leveling sensor has been removed before adjusting Z0
B
Use Part
B-2-2
1211
Move the A4 paper to test
the distance of nozzle from
the platform
To Next Page
Loading...
