electric front motor to brake which at the same time recovers energy to
charge your battery and extend your range.
Speed Limit Setting
Your scooter is equipped with 5 speed modes that can be set depending on
your desired speed limit. L4 is set by default.
1. Turn the scooter off. Press the electric brake lever and hold during
the entire operation.
2. Turn the scooter on. The display will show “SET” and L1,2,3,4, or 5.
3. Press the settings button to switch between the different speed
limit levels:
L1 = 5mph, L2 = 10mph, L3 = 16mph, L4 = 24 mph, L5 = no limit
4. Release the brake lever to complete operation.
Advanced Settings
Your scooter allows for advanced settings. Experienced riders only!
To configure advanced settings, follow these steps:
1. Turn the scooter on. Press the electric brake lever and hold during
the entire operation.
2. Press the power button. P0 will show in the display
3. Press the light or settings button to cycle through the P-setting
functions.
4. To select a P-setting for configuration, press the power button until
you hear a beep.
5. Change the P-setting with the light or settings button.
6. To save your setting, release the electric brake lever.
P0 – Non-Zero Start (turned ON by default – P0 = 1):
If it is turned ON, you must bring the scooter into motion before the
throttle will work. If turned OFF, you can start the scooter from “zero”,
without being in motion.
WARNING: Non-Zero Start turned ON is an important safety function so
you do not accidentally hit the throttle while you are not riding. Turn
this off at your own risk.
P1 – EBS (set to P1=5 by default):
To Next Page
Loading...
