This setting sets the intensity of the electric brake. You can choose from
0 (lowest electric braking strength) to 5 (highest electric braking
strength).
P2 – Motor Lock (off by default – P2=0):
Turn this on if you would like to lock the front motor so that you cannot
move or operate the scooter without picking it up.
P3 – Cruise Control (off by default – P3 =0):
If turned on, once you maintain a speed for 5 seconds, your scooter will
automatically hold this speed, even if you let go of the throttle. You can
easily deactivate the cruise control speed by pressing the throttle or the
electric brake lever.
WARNING: Only use cruise control once you are fully mastering riding
the scooter. It can be surprising if the scooter does not slow down
when you release the throttle.
Switch from miles to kilometers
By default, the scooter is set to show miles and Fahrenheit. You can
switch the display to kilometers and Celsius instead: Turn the scooter on,
Press and hold the electric brake lever, then press the settings button.
Release the brake lever.
Battery Charge Indicator
There are five battery bars and a charge percentage on the display. As the
battery is drained, the bars will diminish, and the percentage value will
reduce. Keep an eye on your charge to ensure you do not get stranded.
Note that if you request a lot of power (e.g. by riding uphill), the battery
charge indicator may fluctuate downwards due to temporary voltage
reduction when the motor needs more power.
When you turn on the scooter you will see the current battery voltage
displayed in the lower right corner of the display. A fully charged battery
shows >54V.
To Next Page
Loading...
