Fluidmaster EVERYTHING - Step 10: Finishing Installation Steps; Connect Water Supply to Fill Valve; Turn On Water Supply

15
STEP 10: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
*Hand-tighten only. Do not overtighten.
B: TURN ON WATER
Check for leaks.
C: WATER LEVEL
After the tank stops lling, water level should ll the tank to
roughly ½” below top of overow pipe to ensure a proper ush.
(Does not need to be exact.)
1/2"
Overow Pipe
Top of
Overow Tube
Water Level
Lever Hole
*
Overtightening may damage ll valve or coupling nut, potentially causing ooding.
Make sure the oat cup does not touch the tank walls or tank lever and ush valve.
**
The top of the overow pipe must be a minimum of 1" below tank lever hole.