13
Still not working exactly right?
See the next page for Troubleshooting.
YOU DID IT!
We knew you could!
Share your success story
with friends and family!
#FixedMyToilet
#Fluidmaster
STEP 11: FLUSH THE TOILET
A: FLUSH THE TOILET
If you’re satisfied with the flush, YOU’RE DONE!
12
STEP 10: FINE-TUNE BOWL WATER LEVEL
A: FILL BOWL WITH A GALLON OF WATER
Wait 1 minute until the bowl water level recedes
down and stops.
B: MARK THE WATER LEVEL IN THE BOWL
With a pencil, draw a line at the top of the water level
in bowl. (Pencil mark will easily wash off).
C: FLUSH TOILET TO CHECK BOWL
WATER LEVEL
If the water level matches the line you’ve made in
the bowl when the fill valve stops filling the tank,
the water level is correct, proceed to Step 11.
TOO HIGH
TOO LOW
If the water level matches the line in the bowl and the
fill valve is STILL FILLING, then the bowl water is
TOO HIGH, proceed to Step 10D.
If the valve shuts off and the water level does NOT
match the line in the bowl, the water level is TOO
LOW, proceed to Step 10D.
E: FLUSH TOILET,
CHECK BOWL WATER LEVEL
Repeat Steps 10D and 10E until water level in bowl
matches the line when the fill valve shuts off.
D: ADJUST THE BOWL WATER LEVEL
TOO HIGH:
Turn the dial clockwise.
TOO LOW:
Turn the dial counter-clockwise.
LESS WATER
MORE WATER
To Next Page
Loading...
Need help?
General
