Fluke 1508 - Using the Memory Function

Insulation Testers
Using the Memory Function
17
bbv11f.eps
Figure 9. Using the Compare Function
Using the Memory Function
You can store up to 19 insulation or earth-bond
measurements on the Tester. The measurements are
stored in a last in, first out format. If more than 19
measurements are stored, the earliest will be deleted to
make room for the latest.
Storing a Measurement
Press the M button to save the last measurement taken.
Recalling a Measurement
Press the blue button and then the M button to recall the
last saved measurement. The measurement will be
displayed on the primary display and the stored data count
will be displayed on the secondary display. Press the blue
button and the
M button again to recall the previous
saved result. You can repeat this step until the displayed
stored data count is one. The next displayed
measurement will be the newest. Press the
M button to
exit the recall display.
Clearing Memory
Press the blue button and then the L button. The
primary display will show clr?. Press the blue button and
then the L button again to clear all memory locations.