Insulation Multimeters
Safety Information
3
• Replace the battery as soon as the low battery indicator (b) appears.
• Disconnect circuit power and discharge all high-voltage capacitors before testing resistance,
continuity, diodes, or capacitance.
• Do not use the Meter around explosive gas or vapor.
• When using the test leads, keep your fingers behind the finger guards.
• Remove test leads from the Meter before opening the Meter case or battery door. Never operate the
Meter with the cover removed or the battery door open.
• Comply with local and national safety requirements when working in hazardous locations.
• Use proper protective equipment, as required by local or national authorities when working in
hazardous areas.
• Avoid working alone.
• Use only the replacement fuse specified or the protection may be impaired.
• Check the test leads for continuity before use. Do not use if the readings are high or noisy.
Table 1. Symbols
B AC (Alternating Current) J Earth Ground
F DC (Direct Current) I Fuse
X WARNING: risk of electric shock. T Double Insulated
b Battery (Low battery when shown on display.) W Important information; see manual
~ Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for recycling information.
To Next Page
Loading...
