Insulation Multimeters
Safety Information
3
• Do not apply more than the rated voltage between the
terminals or between each terminal and earth ground.
• Limit operation to the specified measurement category,
voltage, or amperage ratings.
• Use Product-approved measurement category (CAT),
voltage, and amperage rated accessories (probes, test
leads, and adapters) for all measurements.
• Measure a known voltage first to make sure that the Product
operates correctly.
• Use the correct terminals, function, and range for
measurements.
• Measure for hazardous voltage without the Low-Pass Filter.
• Do not use the Product if it operates incorrectly.
• Replace the battery when the low battery indicator ()
shows to prevent incorrect measurements.
• Remove the batteries if the Product is not used for an
extended period of time, or if stored in temperatures >50 °C.
If the batteries are not removed, battery leakage can damage
the Product.
• The battery door must be closed and locked before you
operate the Product.
• Remove all probes, test leads, and accessories before the
battery door is opened.
• Do not use the Product if it is damaged.
• Disable the Product if it is damaged.
To Next Page
Loading...
